Jumat, 12 Juli 2013

Setting VLAN




Konfigurasi Switch0:
Switch>ena
Switch#conf t
Switch(config)#vlan  10
Switch(config-vlan)#name dosen
Switch(config-vlan)#exit
Switch(config)#vlan  20
Switch(config-vlan)#name mahasiswa
Switch(config-vlan)#exit
Switch(config)#int fa0/1
Switch(config-if)#switchport access vlan 10
Switch(config-if)#exit
Switch(config)#int fa0/2
Switch(config-if)#switchport access vlan 20

Setting Jaringan Summarization Sederhana

1Pertama buka aplikasi Packet Tracer 5.3, terus buat jaringan seperti yang ada dibawah ini:
Konfigurasi Router0:
Router>ena
Router#conf t
Enter configuration commands, one per line.  End with CNTL/Z.
Router(config)#int fa0/0
Router(config-if)#ip add 172.16.10.1 255.255.255.0
Router(config-if)#no sh
%LINK-5-CHANGED: Interface FastEthernet0/0, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to up
Router(config-if)#exit
Router(config)#int ser2/0
Router(config-if)#ip add 172.16.5.1 255.255.255.0
Router(config-if)#no sh
%LINK-5-CHANGED: Interface Serial2/0, changed state to down
Router(config-if)#clock rate 64000
Router(config-if)#exit
Router(config)#
%LINK-5-CHANGED: Interface Serial2/0, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface Serial2/0, changed state to up
Router(config)#ip route 192.168.0.0 255.255.252.0 ser2/0
Router(config)#exit
%SYS-5-CONFIG_I: Configured from console by console
Router#conf t
Enter configuration commands, one per line.  End with CNTL/Z.
Router(config)#ip route 172.16.1.0 255.255.255.0 ser2/0
Router(config)#exit
%SYS-5-CONFIG_I: Configured from console by console
Router#copy ru
Router#copy running-config st
Router#copy running-config startup-config
Destination filename [startup-config]?
Building configuration…
[OK]
Konfigurasi Router1:

Laman